Explorer Sport Trac 2WD V6-4.0L (2009)
10. Remove the heater tube bracket front bolt.
11. Install the Engine Lifting Bracket using the heater tube bracket front bolt.
-
Tighten to 23 Nm (17 lb-ft).
12. NOTE: This is not a typical setup. Only the right side of the engine will be raised.
Install the Engine Support Bar and the 2 Adapters for 303-290A.
All-Wheel Drive (AWD) vehicles
13. Remove the 4 bolts and the 2 stabilizer bar brackets.
14. Remove the 4 bolts and the crossmember.
All vehicles
15. Remove the RH engine support insulator nut.
16. Remove the LH engine support insulator through bolt.
17. Remove the 2 transmission-to-cylinder block cradle bolts.
18. NOTE: Cylinder block cradle is shown removed for clarity. Note the location of the 2 Torx head bolts at the rear of the cylinder block cradle.
Remove the 2 cylinder block cradle rear bolts.