Explorer Sport Trac 2WD V6-4.0L (2009)
NOTICE: Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may damage the
connector.
NOTE: Failure to disconnect the battery when instructed will result in false resistance readings. Refer to Battery.
-------------------------------------------------
I1 CHECK THE RECORDED DTCs FROM THE SJB SELF-TEST
-
Check the recorded results from the SJB self-test.
-
Is DTC C1788, B2048 or B2050 recorded?
Yes
For DTC C1788, GO to I2.
For DTC B2048 or B2050, GO to I5.
No
GO to I7.
-------------------------------------------------
I2 CHECK THE LH LED MODULE FOR A SHORT TO GROUND
-
Disconnect: LH Rear Lamp C419.
-
Ignition ON.
-
Enter the following diagnostic mode on the scan tool: SJB Self-Test.
-
Clear the DTCs and repeat the SJB on-demand self-test.
-
Is DTC C1788 still present?
Yes
GO to I3.
No
INSTALL a new LED module. RUN the on-demand self-test (required to clear certain DTCs). CORRECT any unresolved DTCs. CLEAR all DTCs.
TEST the system for normal operation.
-------------------------------------------------
I3 CHECK THE RH LED MODULE FOR A SHORT TO GROUND
-
Disconnect: RH Rear Lamp C418.
-
Enter the following diagnostic mode on the scan tool: SJB Self-Test.
-
Clear the DTCs and repeat the SJB on-demand self-test.
-
Is DTC C1788 still present?
Yes
GO to I4.
No
INSTALL a new LED module. RUN the on-demand self-test (required to clear certain DTCs). CORRECT any unresolved DTCs. CLEAR all DTCs.
TEST the system for normal operation.
-------------------------------------------------
I4 CHECK CIRCUIT CLS44 (VT/BN) FOR A SHORT TO GROUND
-
Ignition OFF.
-
Disconnect: SJB C2280a.
-
Measure the resistance between the LH rear lamp C419-1, circuit CLS44 (VT/BN), harness side and ground.