Explorer Sport Trac 2WD V6-4.0L (2009)
GO to Z5.
No
INSTALL a new trailer tow connector. TEST the system for normal operation.
-------------------------------------------------
Z5 CHECK CIRCUIT CAT06 (YE) FOR A SHORT TO GROUND
-
Ignition OFF.
-
Disconnect: SJB C2280a.
-
Measure the resistance between the SJB C2280a-14, circuit CAT06 (YE), harness side and ground.
-
Is the resistance greater than 10,000 ohms?
Yes
GO to Z9.
No
REPAIR the circuit. RUN the on-demand self-test (required to clear certain DTCs). CORRECT any unresolved DTCs. CLEAR all DTCs. TEST the
system for normal operation.
-------------------------------------------------
Z6 CHECK FOR VOLTAGE TO THE TRAILER TOW CONNECTOR
-
Disconnect the trailer from the vehicle.
-
Ignition OFF.
-
For the 4-pin connector, while applying the brake pedal, measure the voltage between the trailer tow C439-2, circuit CAT06 (YE), harness side
and ground.
-
For the 7-pin connector, while applying the brake pedal, measure the voltage between the trailer tow connector pin 1, circuit CAT06 (YE),
component side and ground.
-
Is the voltage greater than 10 volts?
Yes
The vehicle is operating correctly. SEND the trailer to an authorized camper/trailer repair facility. TEST the system for normal operation.
No