ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2813 > < Initial Inspection and Diagnostic Overview|Page 2811
Page 47
background image

-

Is the resistance less than 5 ohms?

Yes

GO to Q17.

No

CONNECT the negative battery cable. GO to Q48.

-------------------------------------------------
Q17 VERIFY VEHICLE EQUIPMENT - DSM

-

Inspect the vehicle for a DSM.

-

Is the vehicle equipped with a DSM?

Yes

GO to Q18.

No

GO to Q19.

-------------------------------------------------
Q18 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TOGETHER WITH THE DSM DISCONNECTED

-

Disconnect: DSM C341c.

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and the DLC C251-11, circuit VDB07 (VT/OG), harness
side.

-

Is the resistance less than 5 ohms?

Yes

GO to Q19.

No

CONNECT the negative battery cable. GO to Q49.

-------------------------------------------------
Q19 VERIFY VEHICLE EQUIPMENT - SDARS MODULE

-

Inspect the vehicle for a SDARS module.

-

Is the vehicle equipped with a SDARS module?

Yes

GO to Q20.

No

GO to Q21.

Initial Inspection and Diagnostic Overview|Page 2813 > < Initial Inspection and Diagnostic Overview|Page 2811