ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2840 > < Initial Inspection and Diagnostic Overview|Page 2838
Page 74
background image

-

Are the resistances greater than 1,000 ohms?

Yes

CONNECT the negative battery cable. GO to S31.

No

GO to S24.

-------------------------------------------------
S24 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE RCM DISCONNECTED

-

Disconnect: RCM C310b.

-

Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and ground; and between the DLC C251-14, circuit
VDB05 (WH), harness side and ground.

-

Are the resistances greater than 1,000 ohms?

Yes

CONNECT the negative battery cable. GO to S32.

No

If the vehicle is equipped with a Transmission Control Module (TCM), GO to S25.

If the vehicle is not equipped with a TCM, GO to S26.

-------------------------------------------------
S25 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE TCM DISCONNECTED

-

Disconnect: TCM C1575.

-

Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and ground; and between the DLC C251-14, circuit
VDB05 (WH), harness side and ground.

-

Are the resistances greater than 1,000 ohms?

Yes

CONNECT the negative battery cable. GO to S33.

No

GO to S26.

-------------------------------------------------

Initial Inspection and Diagnostic Overview|Page 2840 > < Initial Inspection and Diagnostic Overview|Page 2838