ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Engine, A/T Controls - Driveline Bump/Harsh 1-2 Shift|Page 470 > < Engine, A/T Controls - Driveline Bump/Harsh 1-2 Shift
Page 2
background image

(3) Choose Reset KAM.

(4) Choose TCM.

b. Using PDS:

(1) Choose all Tests and Calibrations.

(2) Scroll down the menu and choose reset TCM KAM.

NOTE

FOR PDS, RESET TCM KAM IS NOT THE SAME AS CLEAR TRANSMISSION ADAPTIVE TABLES, WHICH IS UNDER THE
POWERTRAIN - TRANSMISSION MENU TREE.

NOTE

UNHOOKING THE BATTERY WILL NOT CLEAR THE TCM KAM. IT IS CRITICAL THAT TCM KAM BE CLEARED PRIOR TO
RELEARNING THE ADAPTIVE TABLES FOR THE TRANSMISSION.

NOTE

DO NOT CLEAR THE PCM KAM.

4.

Verify that the transmission fluid temperature (TFT) PID is above 175 °F (80 °C). If it is not at 175 °F (80 °C), drive unit approximately 3 miles (5
Km) to reach temperature.

NOTE

TFT MUST BE AT 175 °F (80 °C) OR ABOVE BEFORE PROCEEDING TO STEP 5.

NOTE

Perform Adaptive Shift Strategy learn on Level Surface road.

5.

Drive unit to perform adaptive shift strategy learn.

a. Accelerate from rest with light throttle to 15 MPH (24Km/h), remove foot from accelerator pedal.

b. Brake very gently to a complete stop (allow at least six (6) seconds).

c. Repeat steps (a-b) five (5) times in the dealership parking lot or similar setting.

d. Accelerate from rest with light throttle ensuring that the 1-2, 2-3 and 3-4 shifts occur at engine speeds between 1600-2000 RPM.

e. Continue to accelerate until you achieve 50 MPH (80 Km/h) or the 5-6 upshift.

f.

Brake gently to a complete stop and hold foot on brake for ten (10) seconds.

g. Repeat steps (d-f) three (3) times.

NOTE

THE HARSH BUMP FELT WHILE BRAKING TO A STOP WILL BE IMPROVED. HOWEVER, SEVERAL DAYS OF DRIVING ARE
REQUIRED FOR THE TRANSMISSION TO FULLY ADAPT.

WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage 
IMPORTANT: Warranty coverage limits/policies are not altered by a TSB. Warranty coverage limits are determined by the identified causal part.

OPERATION

DESCRIPTION

TIME

091810A

2009 Explorer,

1.0 Hr.

Mountaineer, Explorer
Sport Trac 6R80
Transmission: Reprogram
The PCM And TCM,
Includes Time To Clear
KAM And Perform Road
Tests (Do Not Use With
12650D)

Engine, A/T Controls - Driveline Bump/Harsh 1-2 Shift|Page 470 > < Engine, A/T Controls - Driveline Bump/Harsh 1-2 Shift