Explorer Sport Trac 2WD V6-4.0L (2009)
4. Disconnect the 2 passenger air bag module electrical connectors.
5. Remove the 4 passenger air bag module nuts.
-
To install, tighten to 9 Nm (80 lb-in).
6. NOTICE: Do not handle the passenger air bag module by grabbing the edges of the passenger air bag cover. Damage to the air bag
module may occur.
Push up to release the passenger air bag cover clips from the instrument panel and remove the passenger air bag module.
7. NOTE: During passenger air bag module installation, make sure all of the air bag trim cover clips are fully seated into the instrument panel.
To install, reverse the removal procedure.
8. Repower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering See: Air Bag(s)
Arming and Disarming/Service and Repair/Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures.