Explorer Sport Trac 2WD V6-4.0L (2009)
5. NOTE: Make sure all safety canopy module bolt holes line up with all J-clips.
Install the 2 safety canopy module bolts near the C-pillar.
-
Tighten to 8 Nm (71 lb-in).
6. Install the safety canopy module C-pillar tether bracket and the 2 bolts.
-
Tighten to 12 Nm (106 lb-in).
7. Install the 2 safety canopy module rear bracket bolts.
-
Tighten to 8 Nm (71 lb-in).
8. Install the safety canopy module front 3 bolts.
-
Tighten to 8 Nm (71 lb-in).
9. Attach the 3 safety canopy module front tether pin-type retainers to the A-pillar.
10. NOTE: Make sure the safety canopy module front tether bracket locator tab is correctly installed in the A-pillar sheet metal.
Install the safety canopy module front tether bracket and bolt.
-
Tighten to 8 Nm (71 lb-in).
11. Connect the safety canopy module electrical connector and attach the connector pin-type retainer to the C-pillar.
Vehicles with moon roof
12. NOTE: Make sure to route the moon roof drain hose as noted during removal.
Connect the rear moon roof drain tube and attach the 2 rear moon roof drain hose clips.
All vehicles
13. Install the headliner.
14. Repower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering See: Air Bag(s)
Arming and Disarming/Service and Repair/Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures.