Explorer Sport Trac 2WD V6-4.0L (2009)
2. Remove the seat and depower the SRS.
3. Remove the safety belt buckle pretensioner electrical connector cover.
4. Disconnect the safety belt buckle electrical connectors.
5. Remove the 2 nuts and safety belt buckle pretensioner.
-
To install, tighten to 36 Nm (27 lb-ft).
6. NOTE: Before installation, make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.
To install, reverse the removal procedure.
7. Install the seat and repower the SRS. If the passenger seat has been serviced, do not prove out the SRS at this time.
8. Check the active restraint system for correct operation. For additional information, refer to the appropriate Functional Test procedure in Safety
Belt System See: Testing and Inspection/Component Tests and General Diagnostics.