Explorer Sport Trac 2WD V6-4.0L (2009)
10. NOTE: Do not overfill the reservoir.
Fill the reservoir.
-
Use approved transmission fluid.
11. Start the engine.
12. Install the Power Steering Evacuation Cap and the Vacuum Pump Kit. Apply and maintain the maximum vacuum of 68-85 kPa (20-25 in-Hg).
13. NOTICE: Do not hold the steering wheel against the stops for an extended amount of time. Damage to the power steering pump may
occur.
Cycle the steering wheel fully from stop-to-stop 10 times.
14. Stop the engine, release the vacuum and remove the Vacuum Pump Kit and the Power Steering Evacuation Cap.
15. NOTE: Do not overfill the reservoir.
Fill the reservoir as needed and install the reservoir cap.
16. Visually inspect the power steering system for leaks.
17. NOTE: Do not overfill the reservoir.
Fill the reservoir as needed and visually inspect the power steering system for leaks.
18. Install the reservoir cap.