Explorer Sport Trac 2WD V6-4.0L (2009)
4. Remove the sensor.
Assembly
1. NOTICE: Damage to the sensor may occur if excessive force is applied during sensor installation.
NOTE: Make sure the sensor is fully seated into the cradle. The sensor will make a "click" noise when correctly seated.
Position the sensor into the cradle by inserting the hinge end of the sensor into the hook end of the cradle and pushing the opposite end of the
sensor down onto the cradle.
2. NOTE: The locking clip can only be fully seated when installed in the correct orientation. If the sensor locking clip cannot be fully inserted, then
the sensor may not be fully seated on the cradle or the locking clip may be inserted backward.
Insert a new locking clip into the sensor.
3. NOTICE: The sensor, cradle and strap may be damaged by incorrect tire mounting or dismounting. Mount the tire only as instructed.
Install the tire onto the wheel. For additional information, refer to Wheel and Tire See: Service and Repair/Overhaul.
4. NOTE: A new tire pressure sensor is shipped in an off mode (or battery saver mode) and must be turned on before it can be trained. To turn the
sensor on, install it on a wheel, mount the tire and inflate the tire to the recommended inflation pressure. Wait at least 2 minutes, then continue
with the sensor training procedure.
Train the tire pressure sensor(s). For additional information, refer to Tire Pressure Monitoring System (TPMS) Sensor Training See: Tire
Monitoring System/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes.