Explorer Sport Trac 2WD V6-4.0L (2009)
7. Remove the transfer case.
8. Using the Input Shaft Oil Seal Remover and Slide Hammer, remove the output shaft seal.
Installation
RWD vehicles
1. Install the slip plane washer.
2. Position a new output shaft seal.
3. Using the 6R80 Rear Seal 4X2 Installer, install the output shaft seal.
4. Install the output shaft flange.
5. Install the extension housing flange seal and a new output shaft flange nut.
-
Tighten to 80 Nm (59 lb-ft).
-
After installing the new output shaft flange nut, it must be staked at the slots to prevent it from coming loose.