Explorer Sport Trac 2WD V6-4.0L (2009)
Disconnect the transmission vehicle harness connector.
4. NOTE: The transmission fluid pan gasket is reusable, clean and inspect for damage. If not damaged, the transmission fluid pan gasket should be
reused.
Remove the 16 transmission fluid pan-to-case screws, transmission fluid pan and transmission fluid pan gasket.
5. Remove the transmission fluid filter.
6. NOTICE: Do not damage the solenoid body connector pins.
Remove the transmission control solenoid body screws and remove the transmission control solenoid body by pulling down on the transmission
control solenoid body and pushing down on the transmission solenoid body connector from the other side of the case.
Installation
1. Install new O-ring seals on the transmission control solenoid body connector. Lubricate the O-ring seals with transmission fluid.
2. NOTICE: Inspect the transmission case bore to make sure it is free of foreign material and not damaged. If damaged, a transmission leak
may occur.
Install the transmission control solenoid body. Tighten the transmission control solenoid body screws in sequence shown.