Explorer Sport Trac 2WD V6-4.0L (2009)
Removal
1. NOTICE: The color on the rear face of the drive pinion nut is critical to this repair. Use the same color new drive pinion nut for
installation. If a new collapsible spacer must be installed for pinion bearing preload reduction, install the nut supplied with the new
spacer kit or damage to the component may occur.
With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the rear wheel brake disc.
3. Remove the rear driveshaft.
4. Install a Nm (lb-in) torque wrench on the pinion nut and record the torque necessary to maintain rotation of the drive pinion gear through several
revolutions.
NOTICE: The color on the rear face of the drive pinion nut is critical to this repair. Use the same color new drive pinion nut for installation or
damage to the component may occur.
5. Using the Drive Pinion Flange Holding Fixture to hold the pinion flange, remove and discard the pinion nut.
6. Index-mark the pinion flange and drive pinion gear to maintain initial balance during installation.
7. Using the 2-Jaw Puller, remove the pinion flange.
8. If necessary, use a screwdriver to force up the metal flange of the pinion seal. Install gripping pliers and strike with a hammer to remove the drive
pinion seal.
