Explorer Sport Trac 2WD V6-4.0L (2009)
Removal
1. Remove the driveshaft. For additional information, refer to Driveshaft - Rear, One-Piece, 4.6L (3V) See: Driveshaft - Rear, One-Piece.
2. Index-mark the driveshaft on both sides of the driveshaft slip yoke boot.
3. Remove and discard the 2 driveshaft slip yoke boot clamps.
4. Separate the driveshaft.
5. Remove the driveshaft slip yoke boot.
Installation
1. NOTE: Grease both ends of the driveshaft.
Position the driveshaft slip yoke boot and the 2 driveshaft slip yoke boot clamps on one end of the driveshaft.
2. Align the index marks and connect the driveshaft.