Explorer Sport Trac 2WD V6-4.0L (2009)
Front Door Window Glass Weatherstrip: Service and Repair
Door Glass Top Run - Front
Door Glass Top Run - Front
Removal and Installation
NOTE: For LH front only, the front window motor must be initialized whenever the front window motor is removed from the window regulator drum
housing, a new window regulator is installed, a new top run is installed or for any operation in which grease or lubricants are applied to the window
regulator or glass run.
1. Remove the front door window glass. For additional information, refer to Window Glass - Front Door See: Service and Repair/Window Glass -
Front Door.
2. Remove the exterior moulding.
3. Remove the front door glass top run channel assembly bolt.
-
To install, tighten to 12 Nm (106 lb-in).
4. Remove the front door glass top run channel assembly through the top opening of the front door.
5. To install, reverse the removal procedure.
-
For LH front window only, initialize the LH front window motor. For additional information, refer to Window Motor Initialization - Front
See: Service and Repair/Window Motor Initialization - Front.