Explorer Sport Trac 2WD V6-4.0L VIN E (2002)
11. Disconnect the Crankshaft Position (CKP) sensor electrical connector.
12. Remove the wiring anchors and position the wiring aside.
13. Raise and support the vehicle.
14. On all models, disconnect the transmission portion of the wiring harness.
1
Disconnect the RH and LH Heated Oxygen Sensor (HO2S) connectors.
2
Disconnect the transmission control connector.
3
Disconnect the Output Shaft Speed (OSS) sensor connector.
4
Disconnect the digital Transmission Range (TR) sensor connector.
15. Disconnect the catalyst monitor sensor electrical connector.
16. Release the transmission/transfer case portion of the wiring harness from any routing clips or pushpins.
17. Route the transmission/transfer case portion of the wiring harness to the top of the engine.
18. Lower the vehicle.
19. Remove the wiring harness from the vehicle.
INSTALLATION
