Explorer Sport Trac 2WD V6-4.0L VIN E (2002)
SHOULD BE REPLACED UNLESS A QUALIFIED TECHNICIAN FINDS THE ASSEMBLIES SHOW NO DAMAGE AND OPERATE
PROPERLY. BELT ASSEMBLIES NOT IN USE DURING A COLLISION SHOULD ALSO BE INSPECTED AND REPLACED IF EITHER
DAMAGE OR IMPROPER OPERATION IS NOTED.
NOTE: Passenger side shown, driver side similar.
1. Remove the B-pillar trim panel.
2. Remove the front safety belt retractor.
1
Remove the bolt.
2
Using the special tool, remove the bolt.
3
Remove the front safety belt retractor.
INSTALLATION
1. Install the front safety belt retractor.
1
Position the front safety belt retractor to the B-pillar.
2
Using the special tool, install the front safety belt retractor bolt.
3
Install the bolt, being careful not to overtighten.
NOTE: Make sure to tighten nuts and bolts to specification.
2. Install the B-pillar trim panel.
3. Check the active restraint system for correct operation.