Explorer Sport Trac 4WD V6-245 4.0L SOHC VIN K SFI (2001)
Front Bumper Reinforcement: Service and Repair
FRONT BUMPER
Removal and Installation
1. Remove the front bumper cover.
2. If equipped, remove the two fog lamp assemblies.
1. Disconnect the electrical connectors.
2. Remove the six bolts (three each side).
3. Remove the two fog lamp assemblies.
3. WARNING: To avoid possible injury, support the front bumper before removing the nuts.
Remove the four nuts (two each side) and the front bumper.
4. To install, reverse the removal procedure.
