Ford Explorer Sport Trac 4WD V6-245 40L SOHC VIN K SFI HVAC Housing Assembly Service
Housing Assembly HVAC: Service and Repair
REMOVAL
1. Prepare the vehicle for plenum chamber removal.
1
Remove the dash board. Refer to: Body and Frame, Interior Trim, Dashboard/Instrument Panel, Service and Repair, Removal and
Installation, See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair
2
Remove the A/C evaporator housing, please refer to Heating and Air Conditioning/Evaporator Case/Service and Repair/ See: Evaporator
Case/Service and Repair
3
Remove the Powertrain Control Module (PCM), please refer to Powertrain Management/Computers and Controls/Engine Control
Module/Service and Repair/ See: Powertrain Management/Computers and Control Systems/Powertrain Control Module/Service and Repair
2. Remove the PCM heat sink.
1
Remove the ground strap screw.
2
Remove the PCM heat sink
3
Remove the four nuts and the plenum chamber.
NOTE: To ease the removal of the plenum chamber, first remove the nut located at the center of the dash panel behind the engine cylinder block.
INSTALLATION
1. To install, reverse the removal procedure.
