Explorer Sport Trac 4WD V6-4.0L VIN E (2007)
Body / Frame Mount Bushing: Service and Repair
Body Support - Front End Sheet Metal
Body Support - Front End Sheet Metal
Body Support Front End Sheet Metal
Removal and Installation
CAUTION: When removing the front upper body mounts, enough adjacent body mount support bolts or nuts must be removed to prevent
damage occurring to the vehicle.
NOTE:
-
Do not reuse body support mounting fasteners. New fasteners must be installed for each fastener that has been removed or loosened.
-
No lubricants of any kind are to be used during body mount support installation.
1. Remove the body support nut.
-
To install, tighten to 55 Nm (41 lb-ft).
2. Remove the body support washer.
3. Remove the body support bolt.
-
To install, tighten to 55 Nm (41 lb-ft).
4. Remove the front end sheet metal body support lower mount.
5. NOTE: Body mounts must be held with a wrench on the bottom while loosening the nuts from the top.