Explorer Sport Trac 4WD V6-4.0L VIN E (2007)
14. From under the rear of the passenger seat, detach the passenger seat side air bag module electrical connector from the seat track bracket. Then
slide and disengage the passenger seat side air bag module electrical connector locking clip, and then release the tab and disconnect the passenger
seat side air bag module electrical connector.
15. Attach the restraint system diagnostic tool to the vehicle harness side of the passenger seat side air bag module electrical connector.
Vehicles without safety canopy modules
16. CAUTION: Do not deactivate the safety canopy module circuit by removing the safety canopy bridge resistor from the safety canopy
electrical connector.
If the safety canopy bridge resistor is removed, an open circuit fault will be generated by the RCM. If a restraint system diagnostic tool is installed
at the safety canopy electrical connector, a low resistance fault will be generated by the RCM.
Explorer and Mountaineer vehicles with safety canopy modules
17. Release and position aside the passenger side C-pillar trim panel.