Explorer Sport Trac 4WD V6-4.0L VIN E (2007)
-
Install the latch feet retracting link bolt into the kneeling mechanism inboard leg.
-
Tighten to 8 Nm (71 lb-in).
16. Position the inboard and outboard recliner inner covers.
17. Align the cushion trim cover to the cushion foam pad and attach the hook-and-loop strips.
18. Position the cushion foam pad and trim cover to the cushion frame and attach the cushion trim cover retainers and pin-type retainers.
-
Make sure the LATCH is accessible to the occupant.
19. Position the latch feet release bar and install the 2 screws.
20. Install the second row, 40 percent E-Z entry seat backrest.
21. Lower the backrest and position the seat to the E-Z entry position.
-
The latch feet should be released from the mounting plate and the cushion and backrest must be pivoted up.
22. Using the kneeling mechanism release handle on the backrest, pull the handle and position the kneeling mechanism down in the fold flat load floor
position.
-
The cushion and backrest of the seat will be in the E-Z entry position and the kneeling mechanism will be in the fold flat load floor position.
23. NOTE: The shock should be fully extended when installed.
Position and install the shock onto the seat assembly.
24. Install the second row, 40 percent E-Z entry seat into the vehicle.
25. Cycle the backrest down and then back to the upright position. Make sure the inboard and outboard recliners simultaneously and securely lock in
the upright position.
Seat Cushion - Second Row, 60 Percent, E-Z Entry
SEAT CUSHION - SECOND ROW, 60 PERCENT, E-Z ENTRY
