Explorer Sport Trac 4WD V6-4.0L VIN E (2007)
^
To install, tighten to 9 Nm (80 inch lbs.).
3. Remove the 2 screws and LH heater duct.
4. Disconnect the stability control sensor cluster electrical connector.
5. Remove the stability control sensor cluster electrical harness retainers and position aside.
6. Remove the 2 stability control sensor cluster bracket nuts and the stability control sensor cluster.
^
To install, tighten to 7 Nm (62 inch lbs.).
7. To install, reverse the removal procedure.
