Explorer Sport Trac 4WD V6-4.0L VIN E (2007)
6. CAUTION: Do not damage the solenoid body connector pins.
Remove the solenoid body bolts and remove the solenoid body by pulling down on the solenoid body and pushing down on the connector from the
other side of the case.
Installation
1. Install new O-ring seals on the solenoid body connector. Lubricate the O-ring seals with clean automatic transmission fluid.
2. CAUTION: Inspect the transmission case bore to make sure it is free of foreign material and not damaged. If damaged, a transmission
leak may occur.
Install the solenoid body. Tighten the bolts in sequence shown.
^
Tighten to 8 Nm (71 inch lbs.)