Explorer Sport Trac 4WD V6-4.0L VIN E (2007)
3.
Install the foam to the outboard side of the bracket at the center of the rectangle opening so that it wraps to the inside sur[ace of the bracket. This
will provide a load barrier once the PCM is reinstalled. (Figure 1)
4.
Install the PCM. (Refer to WSM, Section 303-14)
5.
Make sure the Heating Ventilation Air Conditioning (HVAC) case vacuum line is not touching the PCM or PCM bracket. Reroute as needed.
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage
IMPORTANT: Warranty coverage limits/policies are not altered by a TSB. Warranty coverage limits are determined by the identified causal part.
OPERATION
DESCRIPTION
TIME
080103A
2006-2008
0.5 Hr.
Explorer/Mountaineer
2007-2008 Explorer Sport
Trac: Install Foam To The
Outboard Side Of The
PCM Bracket, Includes
Time For Diagnosis And,
Remove And Install PCM
(Do Not Use With
12650D6)
DEALER CODING
CONDITION
BASIC PART NO.
CODE
12A659
07
Disclaimer