Explorer Sport Trac 4WD V6-4.0L VIN E (2007)
-
Inspect the safety canopy before installation. If the safety canopy is damaged or the cover has separated and the canopy material has been exposed,
a new safety canopy module must be installed. Do not attempt to repair the safety canopy module. Failure to follow these instructions can result in
personal injury in the event of a safety canopy module deployment.
-
Never put any type of fastener or tie strap around any part of the safety canopy module or interior trim panel. This will prevent the safety canopy
module from deploying correctly. Failure to do so can result in personal injury in the event of a safety canopy module deployment.
-
The safety canopy must be installed in the vehicle using new torque-prevailing type J-nuts (W520822, 8 per side). Use of this J-nut is mandatory
so as to reduce the risk of loss of fastener effectiveness. Failure to follow these instructions may result in personal injury in the event of a safety
canopy deployment.
All vehicles
1. Remove the front 4 J-nuts and install new.
2. Remove the rear 4 J-nuts and install new.
3. Position the safety canopy module by moving it rearward, installing the rear bracket hook in the sheet metal.
