Explorer Sport Trac 4WD V6-4.0L VIN E (2007)
-
The RH and LH C-pillar mounted side impact sensors are not interchangeable.
1. Depower the system.
2. Remove the rear door scuff plate.
3. Detach the rear door weatherstrip.
4. Remove the 2 lower C-pillar trim panel retaining clips from the rear door opening sheet metal.
5. Position aside the lower C-pillar trim panel.
-
Pull out on the quarter trim panel at the C-pillar to release the 3 retaining clips and access the C-pillar side impact sensor.
6. WARNING: The tightening torque of the air bag side impact sensor retaining bolts is critical for correct system operation.
NOTE:
-
Note the position of the sensor and bracket locating tab for installation.
-
Make sure the C-pillar and side impact sensor mating surfaces are clean and free of foreign material.
Remove the 2 bolts from the side impact sensor and bracket assembly.
-
To install, tighten to 12 Nm (9 lb-ft).
7. Disconnect the electrical connector and remove the side impact sensor.
8. To install, reverse the removal procedure.
9. Repower the system.
Front Door
SIDE IMPACT SENSOR - FRONT DOOR