Explorer Sport Trac 4WD V6-4.0L VIN E (2007)
Transmission Mount: Service and Repair
Transmission Support Insulator - Four Wheel Drive (4WD)
Removal
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Support the transmission with a transmission jack.
3. Remove the 2 nuts from the rear transmission support.
4. NOTE: Crossmember and exhaust system shown removed.
NOTE: LH shown, RH similar.
Remove the 2 bolts and remove the rear transmission support.
Installation
1. Install the rear transmission support and bolts.
^
Tighten to 90 Nm (66 ft. lbs.)
2. Lower the rear mount onto the crossmember and tighten the rear transmission support nuts.
^
Tighten to 90 Nm (66 ft. lbs.)