Explorer Sport Trac 4WD V6-4.0L VIN E (2007)
Removal and Installation
1. CAUTION: Do not loosen the front axle wheel end nut until after the wheel and tire assembly are removed from the vehicle. Wheel
bearing damage will occur if the wheel bearing is unloaded with the weight of the vehicle applied.
With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Remove the front wheel and tire assembly.
3. Remove and discard the front axle wheel end nut.
^
To install, tighten to 200 Nm (148 ft. lbs.)
4. CAUTION: To prevent damage to the brake hose, do not allow the disc brake caliper to hang suspended from the hose.
Remove the 2 disc brake caliper guide pin bolts and position the disc brake caliper aside.
^
To install, tighten to 33 Nm (24 ft. lbs.)
^
Using mechanic's wire, position the disc brake caliper aside.