Explorer Sport Trac 4WD V6-4.0L VIN E (2007)
![background image](/ford/explorer_sport_trac_4wd/v6-4.0l_vin_e/Page-1586009.png)
2. Using the special tool, install the boot clamps.
3. CAUTION: Install a new circlip every time the halfshaft is removed from the axle.
CAUTION: Start one end of the circlip in the groove and work the circlip over the halfshaft and into the groove to prevent the circlip
from overexpanding.
Install a new retainer circlip.
4. Remove and discard the inboard halfshaft excluder seal, if equipped.
5. For the inboard CV joint:
1
Position the clamp on the interconnecting shaft.
2
Position the boot on the interconnecting shaft.
3
Install the tri-lobe insert.