Explorer Sport Trac 4WD V6-4.0L VIN E (2007)
3.
Remove and discard the rear axle wheel end nut. To install, tighten to 203 lb-ft (275 N.m). (Figure 1)
CAUTION
DO NOT USE A HAMMER TO SEPARATE THE REAR AXLE HALFSHAFT ASSEMBLY FROM THE HUB. DAMAGE TO THE THREADS
AND INTERNAL CONSTANT VELOCITY (CV) JOINT COMPONENTS MAY RESULT.
4.
Use the special tool, press the outboard constant velocity (CV) joint until it is loose in the hub. (Figure 2)
5.
Use a brush and apply Motorcraft(R) Silicone Brake Caliper Grease and Dielectric Compound to lubricate the rear axle halfshaft dust seal.
6.
Reverse steps 2 and 3 to install halfshaft, tire, and wheel.
Parts Block
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage
IMPORTANT: Warranty coverage limits/policies are not altered by a TSB. Warranty coverage limits are determined by the identified causal part.
OPERATION
DESCRIPTION
TIME
081906A
2006-2008
0.5 Hr.
Explorer/Mountaineer,
2007-2008 Explorer Sport
Trac: Lubricate One Rear
Constant Velocity Outboard
Joint to Knuckle Dust Seal:
0.5 Hrs(Do Not Use With
4139A, 5968A)