Explorer Sport Trac 4WD V6-4.0L VIN K Flex Fuel (2004)
5. Press the power rear window control switch vent button six times.
6. Turn the ignition to the ON position. The power rear window will move down-up-down-up approximately 20 mm (0.8 in). This movement
indicates that the power rear window motor has entered initialization mode.
7. Rotate and hold the power rear window control switch to the CLOSE position until the window stalls into the upper header seal.
8. Momentarily rotate the power rear window control switch to the OPEN position and release. The power rear window will carry out a one-touch
down operation until the window stalls at the bottom of the travel stop designed into the window regulator.
9. Rotate and hold the power rear window control switch to the CLOSE position. Continue to hold the switch until after the window stalls into the
upper header seal and carries out the down-up movement. This down-up movement is approximately 20 mm (0.8 in). This movement indicates
that the power rear window motor has been successfully initialized.
10. Verify correct operation of the power rear window by moving the window to the fully open, vent, then fully closed positions. If the window does
not operate correctly, carefully repeat this procedure.