Explorer Sport Trac 4WD V8-4.6L VIN 8 (2007)
12. Disconnect the safety belt buckle and pretensioner electrical connector and safety belt buckle switch electrical connector.
13. Release all the cushion trim cover retainers.
14. Remove the seat cushion foam pad and cushion trim cover.
15. Remove the 4 cushion frame-to-seat track nuts and the seat track.
-
To install, tighten to 36 Nm (27 lb-ft).
Driver seat with failed horizontal motor
16. If necessary, remove the inboard horizontal screw block bolt. This will allow the inboard power seat track to move independently so the safety belt
buckle and pretensioner can be removed.
All seats
17. To install, reverse the removal procedure.
18. Install the front seat and repower the SRS. If a passenger seat has been serviced, do not prove out the SRS at this time.
Passenger seat
19. Carry out the Occupant Classification Sensor (OCS) System Zero Seat Weight Test and prove out the SRS.
