Explorer Sport Trac AWD V8-4.6L (2010)
2. Remove the 4 screws and the front floor console stowage door.
3. Remove the 2 screws and the front floor console rear trim panel.
-
Pull straight back to disengage the clips.
4. Remove the 2 screws and the front floor console finish panel.
-
Pull straight up to disengage the clips.
5. Remove the front floor console stowage bin.
-
Remove the 4 screws.
-
Disconnect the audio input jack electrical connector.
-
Disconnect the Universal Serial Bus (USB) port electrical connector.
-
Disconnect the APIM electrical connector.
-
Disconnect the USB cable electrical connector (at the APIM).
6. Remove the 4 screws and the APIM.
7. To install, reverse the removal procedure.
-
If a new APIM is being installed, program the APIM to the correct software level. For additional information, refer to Information Bus.