F 100 2WD Pickup V8-302 5.0L (1983)
FIGURE 21
7.
Install the plastisol coated seat back latch striker procured in Step #1. (Figure 21). Torque the attaching screws to 17-27 N-m (12-20 lbs.ft.).
8.
With the seat cushion in the upright position, measure 1/4" directly rearward from the center of
the existing inboard scuff plate attaching hole and drill a 1/8" diameter hole in the frame as shown in Figure 21. (1978-82 units only).
9.
Install the seat cushion trim cover. (Refer to Section 41-60 of the appropriate Truck Shop Manual).
10.
Using an awl, locate through the trim cover the newly drilled hole in the seat cushion frame, then install the rubber bumper (1978-82 units only).
For 1983 units, install the rubber bumper in its original location (Figure 22).
11.
Install the seat back to the seat cushion as outline in Section 41-25 of the appropriate Truck Shop Manual.
12.
Install the seat and track assembly in the vehicle as outlined in Section 41-01 of the appropriate Truck Shop Manual. Torque the seat track to floor
pan, attaching screws to 25-44 N-m (18-32 lbs.ft.).
13.
Install the seat belt assemblies as outlined in Section 41-50 of the appropriate Truck Shop Manual, Torque the seat belt to floor pan, attaching
bolts to 30-43 N-m (22-32 lbs.ft.).
14.
Check the seat tracks and seat latch for proper operation