F 100 2WD Pickup V8-302 5.0L (1983)
and install in vehicle.
12.
Install axle vent into new hole that was drilled and tapped in the above steps. Reconnect rubber vent hose to axle vent.
NOTE:
Make sure vent hose is not plugged.
13.
Fill axle assembly with Hypoid Gear Lubricant (C6AZ-19580-E).
NOTE:
Make sure vehicle is level. Do not overfill axle assembly. ONLY GL6 (C6AZ-19850-E) Lubricant should be, used. Use of lesser quality
lubricants (i.e., GL4, GL5) may cause premature wear of the axle carrier. Limited slip carriers must have friction modifier added.
OTHER APPLICABLE ARTICLES:
None
WARRANTY STATUS:
Reimbursable within the provisions of the Warranty and Policy Manual
OPERATION: SP871218A - Steps 1-5
TIME: 0.6 Hr.
OPERATION: SP871218B - Steps 6-13
TIME: 2.8 Hrs. Use "M" time for auxiliary equipment such as snow plow frames.
DLR. CODING: Basic Part No. 3010 - Code: 77