F 100 2WD Pickup V8-400 6.6L (1982)
Wheel Bearing: Service and Repair
EXC. 4 WHEEL DRIVE MODELS
1.
Raise and support front of vehicle and remove front wheels.
2.
Remove brake caliper and position aside, leaving brake lines attached. Do not allow weight of caliper to hang on brake lines.
3.
Remove grease cap, cotter pin, locknut, adjusting nut and washer, then the outer bearing cone and roller.
4.
Remove hub and rotor and discard grease retainer.
5.
Remove inner bearing and roller.
6.
Reverse procedure to install. Adjust bearings as described under ``Wheel Bearings, Adjust''.
4 WHEEL DRIVE MODELS
1.
Raise and support front of vehicle and remove front wheels.
2.
On models equipped with locking hubs, remove hubs as described in ``Front Wheel Drive Section''.
3.
On 1980---81 models, remove front hub grease cap.
4.
On 1980---81 models, remove driving hub snap ring, then the splined driving hub and pressure spring.
5.
On all models, remove wheel bearing locknut, lock ring and adjusting nut, then the hub and disc assembly. The outer bearing and roller
assembly will slide out when the hub is removed.
6.
Remove inner bearing and grease seal from wheel hub using a suitable driving tool on 1980---81 models or a puller on 1982---87 models.
7.
Reverse procedure to install. Adjust bearings as described under ``Wheel Bearings, Adjust''.
