F 150 2WD V8-4.6L (2008)
1. NOTE: The connecting rod must be installed into the piston with identification markings toward the front.
Position the connecting rod in the piston.
2. NOTE: Lubricate the piston pin and retainers with clean engine oil.
Install the piston pin and the 2 piston pin retainers.
3. NOTE: Lubricate all the piston rings and the piston oil control spacer with clean engine oil.
Install the lower piston oil control segment ring.
4. Install the piston oil control spacer.
5. Install the upper piston oil control segment ring.
6. Install the lower piston compression ring.
7. Install the upper piston compression ring.