F 150 2WD V8-4.6L (2008)
All vehicles
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Drain the engine oil.
3. If equipped, remove the 4 skid plate bolts and the skid plate.
4. Remove the bolts and the crossmember.
Four wheel drive (4WD) vehicles
5. Position a suitable hydraulic jack under the front axle. Securely strap the jack to the axle.
6. NOTE: Rotate the steering column so the pinch bolt for the steering column coupling allows clearance for the isolator bolt.
Remove the upper front axle carrier mounting bushing bolt.
7. Remove the axle shaft housing carrier bushing bolt.
