F 150 2WD V8-4.6L (2008)
Clean and inspect the mating surface.
Installation
1. NOTE: The rear crankshaft seal retainer plate does not have a sealant groove. Gasket maker must be applied to the rear crankshaft seal retainer
plate mating surface on the engine block.
Apply a bead of gasket maker to the rear crankshaft seal retainer plate mating surface on the engine block.
2. Position the crankshaft seal retainer plate and tighten the bolts in the sequence shown.
^
Tighten to 10 Nm (89 lb-in).
3. NOTE: Lubricate the crankshaft rear seal with clean engine oil prior to installation.
Using the special tools, install a new crankshaft rear seal.
4. NOTE: Lubricate the crankshaft oil slinger with clean engine oil prior to installation.
Using the special tools, install a new crankshaft oil slinger.