F 150 2WD V8-4.6L (2008)
Harley Davidson (Part 2)
Removal
CAUTION: Do not use oil or grease-based lubricants on the isolators. These lubricants may cause deterioration of the rubber. This can lead
to separation of the isolator from the exhaust hanger bracket during vehicle operation.
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. NOTE: If a new exhaust intermediate pipe-to-muffler assembly Torca(R) clamp is required, a new exhaust intermediate pipe and Torca(R) clamp
assembly must be installed.
Loosen the exhaust intermediate pipe-to-muffler and tailpipe assembly clamp.
3. Remove the bolt and the front muffler exhaust hanger bracket and isolator from the frame.
4. Remove the bolt and the rear muffler exhaust hanger bracket and isolator from the frame.
5. Remove the bolt and the tailpipe exhaust hanger bracket and isolator from the frame.