F 150 2WD V8-4.6L (2008)
Daytime Running Lamp Resistor: Service and Repair
DAYTIME RUNNING LAMPS (DRL) RESISTOR
Removal and Installation
NOTE: Make sure the headlamp switch and the ignition switch are in the OFF position.
1. Remove the radiator side air deflector.
-
Remove the pin-type retainer.
2. Disconnect the DRL resistor electrical connector.
3. Remove the bolt and the DRL resistor.
-
To install, tighten to 5 Nm (44 lb-in).
4. To install, reverse the removal procedure.