F 150 2WD V8-4.6L (2008)
4. Disconnect the A/C pressure transducer electrical connector.
5. Disconnect the condenser inlet fitting.
-
Discard the O-ring seal.
-
To install, tighten to 25 Nm (18 lb-ft).
6. Remove the compressor-to-condenser discharge line.
7. To install, reverse the removal procedure.
-
Install a new gasket seal and O-ring seals.
-
Lubricate the refrigerant system with the correct amount of clean PAG oil.
8. Evacuate, leak test and charge the refrigerant system.