Fuel Pressure Release Procedure for F 150 2WD V8-46L (2008) Maintenance
Fuel Pressure Release: Service and Repair
FUEL SYSTEM PRESSURE RELEASE
Special Tool(s)
Special Tool(s)
1. NOTE: The splash shield is located on the LH frame rail under the driver side door.
Disconnect the splash shield and position aside.
2. Disconnect the electrical connector.
3. Start the engine and allow it to idle until it stalls.
4. After the engine stalls, crank the engine for approximately 5 seconds to make sure the fuel rail pressure has been released.
5. Turn the ignition switch to the OFF position.