F 150 2WD V8-4.6L (2008)
systems increases the risk of serious personal injury or death in a crash.
1. Remove the rear seat backrest.
2. Remove the rear center D-ring bolt and D-ring.
-
To install, tighten to 40 Nm (30 lb-ft).
3. Remove the back of the cab panel insulator.
-
Remove the pin-type retainers.
-
Release the retaining clips and remove the panel insulator.
4. NOTE: The LH safety belt buckle is attached to the safety belt and retractor assembly anchor.
Remove the nut and rear center safety belt anchor and LH safety belt buckle.
-
To install, tighten to 80 Nm (59 lb-ft).
5. NOTE: Make sure the safety belt webbing is not twisted prior to installation.
Remove the bolt and rear center safety belt retractor assembly.
-
To install, tighten to 48 Nm (35 lb-ft).
6. To install, reverse the removal procedure.
7. Check the active restraint system for correct operation.