F 150 2WD V8-4.6L (2008)
the driveshaft slip yoke for wear. Install new components as necessary.
Installation
1. Position the new small driveshaft slip-yoke boot clamp on the driveshaft stub shaft.
2. Slide the small opening end of the slip-yoke boot on the driveshaft stub shaft, as far as it will travel.
3. Using the special tool, crimp the driveshaft slip-yoke boot clamp.
4. Install the driveshaft slip-yoke on the driveshaft.
1
Pull the slip-yoke boot toward the driveshaft. Lubricate the driveshaft splines with long-life grease.
2
Position the new large slip-yoke boot clamp.
3
Align the blind splines, and install the driveshaft slip yoke on the driveshaft.
5. Set the driveshaft assembled length to specification.
1
Remove any excess grease from the slip-yoke boot and driveshaft slip-yoke surfaces.
2
Position the slip-yoke boot in the slip-yoke boot groove.
3
Set the driveshaft assembled length to specification.
^
Measure from the stub shaft weld to the U-joint centerline.
4
Bleed the air from the slip-yoke boot.