F 150 2WD V8-4.6L (2008)
2. NOTE: Never mix yellow and black snap rings on opposing sides.
Remove the shaft from the special tool and install a new yellow snap ring.
3. Repeat steps to install the new bearing cup and snap ring on the opposite side of the driveshaft yoke.
^
If the yellow snap ring will not seat in the snap ring groove, install the black snap rings.
4. Install the driveshaft slip yoke and new bearing cup.
1
Align the index marks made during disassembly and install the driveshaft slip yoke on the U-joint spider.
2
Start a new bearing cup in the driveshaft slip yoke.
^
Check the needle bearings for correct positioning.
3
Position the assembly in the special tool.
4
Press the bearing cup to just below the snap ring groove.
5. Remove the driveshaft from the special tool and install a new yellow snap ring.