F 150 2WD V8-4.6L (2008)
^
Discard the cotter pin.
4. Remove and discard the wheel hub nut.
^
To install, tighten to 400 Nm (296 lb-ft).
5. Remove the brake disc/wheel bearing and wheel hub assembly.
6. CAUTION: Do not apply lubricant to the threaded end of the wheel spindle or incorrect clamp load may occur.
NOTE: Clean the wheel spindle (including the threaded end) of any dirt or grease using the specified solvent before installing the brake disc.
To install, reverse the removal procedure.