F 150 2WD V8-4.6L VIN 8 (2009)
Removal
1. Turn the ignition to OFF.
2. Remove the instrument panel upper bin.
1. Remove the rubber mat.
2. Remove the 2 screws.
3. Remove the instrument panel upper bin.
3. Disconnect the telematics module electrical connector.
4. Remove the 2 screws and the telematics module.
5. To install, reverse the removal procedure.
Installation
1. Position the telematics module and install the 2 screws.
-
Connect the electrical connector.
2. Install the instrument panel upper bin.
1. Position the instrument panel upper bin.
2. Install the 2 screws.
3. Install the rubber mat.
3. Initialize the telematics module.
1. Wait 5 minutes after the modem-antenna is installed.
2. Turn the ignition to RUN.
3. Wait 10 seconds.
4. Start the vehicle and run the engine for 30 seconds.